1988 GOMACO GT8500B trimmer and milling equipment
- S/N: 145732
- Hours: 1800 on the meter
- Engine: Detroit diesel 6V71 (non turbo)
- Trimmer, milling head with teeth. Working width: +/-3.25m
- Electronic desk board and controls
- U/C: 80% OK
- While proceeding the ground, hydraulic conveyor will load directly material into dump trucks.
Proceed anything from natural soils with various types of clays or sands, some type of rock or a combination of these.
Unit is 100% operational.
--------------------------------------------------------------------------
Videos:
- Gomaco GT 8500B trimmer placer - Operating test 1:
https://www.youtube.com/watch?v=jYvjFa7R66Q
- Gomaco GT 8500B trimmer placer - Operating test 2:
https://www.youtube.com/watch?v=VMTM2lFJ96I
- Gomaco GT 8500B trimmer placer - Trimmer head test:
https://www.youtube.com/watch?v=Jzn3nDnkrKQ
- Gomaco GT 8500B trimmer placer - Detroit diesel engine test:
https://www.youtube.com/watch?v=EcbNVEFaYsE
- Gomaco GT 8500B trimmer placer - Rear conveyor test:
https://www.youtube.com/watch?v=DzlmfT5KvcU
-------------------------------------------------------------------------
– Key Points –
*Accurate grade control regardless of trimmed material density
*Less reliance on highly experienced motor grader operators
*Single pass operation saving time
*Ability to place material while trimming behind stringline, saving time and extra equipment
*Ability to place material while trimming into trucks for removal, saving time and extra equipment
*Ability to sense two widely spaced stringlines simultaneously
.JPG)
